Tie-down Back Flow Style Brake Solenoid Manuale Utente Scaricare il pdf

Back Flow Style Brake Solenoid Installation Instructions

• Installs directly in line between the trailer hydraulic activator and the brake line.

•  Adapts to all models of hydraulic actuators

•  Only one electrical connection required between solenoid and vehicle backup light.

DIRECTIONS - VEHICLE WIRING

1. Disconnect trailer hitch and any wiring connectors from the vehicle.

2. Connect a 14 gauge wire to the backup (reverse) light wire of the vehicle. This wire  

 should be of sufficient length to attach to the existing vehicle/trailer wire receptacle. The 

 end of this wire will require a female end that will match the solenoid male connector wire.

3. For ease of use, tape or band the end of the reverse light wire to the vehicle's trailer  

 electrical connector.

DIRECTIONS - SOLENOID INSTALLATION

Caution: Brake fluid can cause damage to painted areas. Use a cloth rag under the

actuator/brake line connection to collect any spilled brake fluid.

1. Remove the brake line and pipe fitting from the rear of the actuator master cylinder. Save 

 the fitting for later use.

2. Screw the solenoid valve into the master cylinder using a thread sealant and tighten.  

 Make sure thread sealant does not obstruct fluid flow.

3. Attach brake line to solenoid. Do not use thread sealant on this connection.

4. Bleed brakes according to brake and actuator manufacturer’s instructions.

5. Install electrical wire from solenoid to the reverse lights of the tow vehicle.

6. Engage parking brake. With engine off and ignition on, check for proper    

 solenoid operation by placing gear shift in reverse. Backup lights should turn on and an 

 audible click should be heard in the solenoid. Make sure backup lights do not engage in 

 any other gear position.

7. Test vehicle in a protected area before traveling on streets or highways.

For further information regarding installation

contact TIE DOWN ENGINEERING, 800-241-1806

#15363

052504,a152

DIRECTIONS - VEHICLE WIRING 1

Sommario

Pagina 1 - DIRECTIONS - VEHICLE WIRING

Back Flow Style Brake Solenoid Installation Instructions• Installs directly in line between the trailer hydraulic activator and the brake line.•  Ad

Commenti su questo manuale

Nessun commento

Tie-down Back Flow Style Brake Solenoid Manuale Utente

Navigare online o scaricare Manuale Utente per Hardware Tie-down Back Flow Style Brake Solenoid. Tie Down Back Flow Style Brake Solenoid User Manual Manuale Utente

Sommario

Commenti su questo manuale

Prodotti e manuali riguardandi Hardware Tie-down Back Flow Style Brake Solenoid